User`s guide

151
CHAPTER 8 - CFW-08 OPTIONS AND ACCESSORIES
8.5
CAB-RP-1
CAB-RP-2
CAB-RP-3
CAB-RP-5
CAB-RP-7.5
CAB-RP-10
Cables used to connect the inverter to the external parallel
interface keypad (HMI-CFW08-RP).
There are6 cablesoptionsrangingin lenghts from1 m (3.28 ft)
to 10 m (32.8 ft). The user must select among these lenghts
according to the requirement.
The cable CAB-RP must be laid separately from the power
wiring by meeting the requirements for the control wiring(refer
to item 3.2.5).
Figure 8.7 -
CAB-RP-X
8.6
HMI-CFW08-RS
Figure 8.6
- Dimensions in mm [in] of the MIP-CFW08-RP
Lateral View
Front View
Figure 8.8
- Dimensions in mm [in] of the HMI-CFW08-RS
External serial keypad:
this interface is mounted external
to the inverters with Nema 12/IP54 degree of protection and
must be used when the copy function is needed:
For more details aboutcopyfunction refer tothedescription
of the parameter P215 in chapter 6.
ItoperateswiththeMIS-CFW08-RS andthe cableCAB-RS-X
,
which length must be chosen according to the needs (up to
10 m (32.8 ft)).
8.4
MIP-CFW08-RP
Interface for the external parallel keypad HMI-CFW08-RP,
installed in the inverter instead of the standard keypad only
when the remote parallel keypad (HMI-CFW08-RP) is used.
TheproceduresforinsertionandremovingoftheMIP-CFW08-RP
are similar to those shown in figure 8.16 for the KCS-CFW08
module.
37
[1.46]
21
[0.83]
43
[1.69]
57
[
2.24]
15.9
[0.63]
58
2.28
98
[3.86]