User`s guide

108
CHAPTER 6 - DETAILED PARAMETER DESCRIPTION
Range
[Factory Setting]
Parameter
Unit
Description / Notes
In the factory default setting, the inverter is started in lo-
cal mode and the key of the HMI-CFW08-P keypad
will select the local/remote mode.
Theinverters withdummypanel (without HMI-CFW08-P
keypad) are factory supplied with P220 = 3.
For more details, refer to item 6.2.6.
P220
(3)
0 to 6
Local/Remote
[ 2 ]
Selection Source
-
Defines the source of the Local/Remote selection.
In application where it is not possible to operate the in-
verter at 2.5 kHz (for instance, due to acoustic noise),
set P219 = 0.00.
Table 6.13
- Configuration of P220 for defining where the Local/
Remote selection is made
models the switching frequency reduction at low speed
for maintaining the performance is not required. This is
possible because theoutputcurrent acquisition circuit is
different in these models.
Itis recommended tosetP219 according totheswitching
frequencyas shown below:
P297 (F
sw
)
4 (5 kHz)
6 (10 kHz)
7 (15 kHz)
Recommended P219
6.00 Hz
12.00 Hz
18.00 Hz
Table 6.12
- Recommended values for P219
P220
0
1
2
3
4
5
6
Local/Remote Selection
Always local mode
Always remote mode
Key of the keypad
(HMI-CFW08-Por HMI-CFW08-RP)
Key of the keypad
(HMI-CFW08-Por HMI-CFW08-RP)
DI2 to DI4
Key of the keypad (HMI-
CFW08-RS) or serial interface
Key of the keypad (HMI-
CFW08-RS) or serial interface
Default Mode
(*)
-
-
Local
Remote
-
Local
Remote
(*)
When inverter is powered up (initialization).