Product Manual

step 1
Insert four plastic end caps (A) into both lever crossbars
(B) and connect crossbars to the two side frames (C)
using screws supplied. Do not tighten screws.
NOTE: All triggers must face toward the center of base.
assembly instructions
step 2
Insert four plastic end caps (A) into leg crossbars (D)
and connect crossbars to the two side frames using
screws supplied.
step 3
Tighten all screws.
The Otter Tub Stand elevates the Otter Bath Chair for
use in the shower. All three Otter Bath Chair sizes fit
on the Shower Stand. It is constructed of aluminum.
recommended use
B
C
E
D
D
B
A
B
maintenance and care
1. Inspect the shower stand periodically for cracks,
breaks, loose or missing parts of malfunctions. If a
product needs service or replacement parts,
contact an authorized Drive dealer.
2. Wash shower stand with soap and water or 10%
bleach.
adjustments
1. To mount Otter Bath chair onto Shower Stand,
position bath chair legs to the highest position and
push down firmly on chair until legs snap into
sockets (E) of shower stand. To remove chair from
Shower Stand, depress red levers and pull legs
upward one at a time.
2. Lock all casters to immobilize and unlock for
mobility.
CAUTION:
Adult supervision is required at all times.