Product Manual

assembly
Your Back2Go comes in one carton completely
assembled.
use
1. Remove both sets of securing straps from
pocket and open Fastex™ buckles. (Fig 1).
2. Place Back2Go on any chair or in a stroller,
wrap both straps around the back and close
the buckles. (Fig 2)
3. Adjust straps to fit tight by moving belt clips.
4. Open zipper on trunk support.
5. Place child in seat and close trunk support.
figure 1
1. To adjust height of laterals, remove knobs (A)
on the back, place the lateral in the
appropriate slot at desired position and
replace knobs. (Fig 1)
2. To adjust width of laterals, loosen knobs (A)
and slide lateral to desired width and tighten
knobs to secure in place.
3. To raise the trunk harness, remove shoulder
straps (B) from Velcro™ strips in the back and
adjust to desired position. (Fig 3)
4. To adjust the width of the harness, remove
lower straps (C) from Velcro ™ straps in the
back and adjust to desired position. (Fig 3)
You can also open the Fastex ™ buckle for
additional width adjustablility.
adjustments
accessories
(sold separately)
CRS 8000 Headrest
figure 2
figure 3
B
C
A