Product Manual

assembly

step 1

Remove screws from pole (B), line up end of pole (B) with leg

sections (A) and insert screws and curved washers (H). Repeat

with second pole (B).

NOTE: Position curve of black plastic end cap of pole (B) to

match leg section (A) angle.

step 2

Place cushioned pad (D) on floor face down.

step 4

Insert all four legs (G) into leg section (A) at desired height.

step 1

Insert push handle bracket (E) into mounting tube (L) on the

back leg section. Make certain that the push button clicks into

hole on underside of mounting tube on the front leg section.

Repeat on second side

step 1

Lay harness (M) on floor and place child on stomach on top of

harness. Place CrawlAbout above child. Attach side straps

to clasps on the underside of cushioned pad doing front side

clasps first. Attach the back straps and then the shoulder

The CrawlAbout can be used with or without

push handles.

To use with push handles:

step 2

Insert push handle (F) into bracket (E) at desired height.

Repeat on second side.

operation

step 2

Adjust harness straps length as needed.

step 3

Adjust leg height to appropriate height.

step 3

Place frame over the pad inserting all four screws ( C) into

frame. Align front of frame with front of pad (Frame and

pad are marked front and back.) Install four nuts (I) onto

screws (C). Cover nuts with black caps (J).

When using without push handle insert large

black end cap (K) into mounting tube (L) on the

back leg section.