Instruction Manual

- 10 -
STEP 8: Attach Wheel Fenders
1. Attach the wheel fenders (#72 & #74) to each side of the oil tank using M10x30 hex bolt (#73),
Ø10 flat washer (#56), Ø10 spring washer (#33) and M10 lock nut (#32).
STEP 9: Attach Hydraulic Hoses
1. Insert clamp (#78) over the bottom hose (#60) and attach to the gear pump (#47) and secure
with clamp over the gear pump end (#47).
2. Place an O ring (#61) onto the exposed threads of the outlet connector (#59) and attach the
hose (#13) to outlet connector (#59).
3. Attach hose (#15) to the oil tank port, place an O ring (#61) over the port and tighten the hose.
Note: Use Teflon tape on all threaded ends to ensure a tight fit.