Use and Care Manual

CONTROLS
1. Squeeze the auger lever (Fig. 21 - A) to spin the auger
and throw snow. To adjust the position of the chute and
chute deflector plate, see "Step 3 - Adjust The Chute &
Deflector Plate (Fig. 13 & Fig. 14)" on page 17.
2. The direction and speed of the snow blower’s motion
is controlled by the shift lever (Fig. 22 - A). There are
four speed settings in forward (towards the left) and
two in reverse (towards the right).
3. Squeeze the drive lever (Fig. 23 - A) to allow the
wheels to spin and move the snow blower.
OPERATION
WARNING! Do not plug in or turn on the tool until it is fully assembled according to the instructions. Read
through and become familiarized with the following procedures of handling and adjusting your tool. Failure to
follow the safety instructions may result in serious personal injury.
20
TURNING THE SNOW BLOWER OFF
1. Release the auger and drive levers.
2. Put the shift lever in the low, forward position (Fig.
24 - A).
3. Run the auger for 30 - 60 seconds to clear out any
remaining snow inside the auger housing or chute, then
release the auger lever.
4. Turn the fuel lever to OFF. This burns the fuel out of
the carburetor and prolongs engine life.
Fig. 21
A
Fig. 22
A
A
MOVE
FORWARD/BACKWARDS
Fig. 23
CAUTION! Always disengage the drive engagement
handle before changing speeds! Failure to perform
this step could lead to clutch or transmission dam-
age and will void the warranty.
NOTE: To shut down the engine immediately, pull the
engine key out.
TIP: turn the chute through its full range of motion a
couple of times to prevent ice buildup.
FORWARD
REVERSE
FASTFAST SLOW
Fig. 24
A
5. Remove the engine key. Store it in a safe place out of
the reach of children.