Use and Care Manual

ASSEMBLY & ADJUSTMENTS

INSTALLING THE LOWER HANDLE (FIG. 1)

1. Remove the four M8x25 hex-head bolts (A), lock

washers (B), and flat washers (C) from the machine

casing.

2. Align the four holes on the lower handle (D) with the

holes on the machine casing.

3. Use the bolts and washers to secure the lower handle

to the casing.

WARNING! Do not plug in or turn on the tool until it is fully assembled according to the instructions. Read

through and become familiarized with the following procedures of handling and adjusting your tool. Failure to

follow the safety instructions may result in serious personal injury.

Fig. 1

Fig. 2

NOTE: Ensure that two knobs are installed on the

left side, and one on the right side (upper hole), as

shown.

INSTALLING THE UPPER HANDLE (FIG. 2)

To install the upper handle onto the lower handle, you

will need to used the pre-installed knobs on the lower

handle.

1. Remove the three M8x50 bolts (A), bent washers (B),

and knobs (C), and nuts (D) from the lower handle as-

sembly.

2. Use the bolts, bent washers, knobs, and nuts to se-

cure the upper handle assembly (E) to the lower handle

assembly, as shown.