Product Manual

USING THE SPRAY GUN (FIG. 13)

Flip the lock tab (Fig. 13 - 1) behind the trigger up or

down until it clicks to apply or remove the safety. Pull

back on the trigger (Fig. 13 - 2) to begin operating

pressure washer. To stop water flow, release trigger.

USING THE SPRAY NOZZLE (FIG. 14)

1. To connect or disconnect spray tip (Fig. 14 - 1), pull

back on the quick-connect collar (Fig. 14 - 2). Insert or

remove spray tip then release the collar.

2. When spray tip is connected, pull on the spray tip to

make sure it is secured.

3. For general cleaning use the 40° spray tip. This option

is for cement walkways.

5. For applying pressure washer detergent, use the black

soap nozzle.

APPLYING DETERGENT

1. Only use the black soap nozzle for detergent.

2. Rinse surfaces with cool water before applying cleaner.

3. Prepare detergent as required. For best results follow detergent directions as supplied by detergent

manufacturer. Remove cap from the detergent container and fill.

4. Spray detergent on surface. For best results use long, even, and overlapping strokes. Allow detergent

to set for about 3 minutes before rinsing, but do not allow the detergent to dry on the surface or it may

cause streaking or damage. Use good judgment.

5. To clean equipment after use, flush water through the spray nozzle for 1-2 minutes then shut off

engine. Soak nozzle in a bucket of clean water to remove detergent. To empty out the soap from the

pressure washer, disconnect the hose found underneath the pressure washer and let the remaining

soap drain out.

WARNING:

Only use detergents or soaps that are specifically designed to be used with

pressure washers. Chemicals which are caustic, such as acids or bleach, can result in serious

injury, property damage, or death. NEVER aim the flow of water at a person or an animal,

especially when using detergent or cleaner.

Fig. 13

Fig. 14

OPERATING YOUR PRESSURE WASHER