Replacement Part List

CLEANING & MAINTENANCE
HIGH PRESSURE HOSE
The high pressure hose can easily be damaged and should
be stored carefully. Do not kink the hose. Do not drive ve-
hicles over the hose. Do not expose the hose to sharp ob-
jects. Inspect the hose for cuts, bulges, or leaks. These can
develop from kinking or wear. If damaged, replace the hose
immediately.
WARNING! To avoid injury from accidental startups, be sure that the tool is switched OFF and disconnected
from the power supply before performing assembly, inspection or adjustments.
WARNING! If the hose is damaged, do not use the
unit or try to repair the hose. Always replace with an
identical part before operation.
SPRAY NOZZLES
Regularly clean the nozzles, preferably after every use, to
prevent the nozzles from clogging and to ensure good per-
formance of the machine.
1. Remove the nozzle from the spray lance.
2. Use a sturdy pin, piece of wire, or metal pick (not includ-
ed) to dislodge any buildup in the spray tip as shown in Fig.
12. Flush water through the back end of the nozzle and spray
wand with your garden hose for 30-60 seconds to remove
any buildup.
GARDEN HOSE ADAPTER
Check the garden hose adapter periodically for deposits.
Clean this filter regularly for maximum performance. Re-
move the garden hose adapter (Fig. 13 - 1) and rinse it with
warm water to clean out debris and buildup before operating
the pressure washer.
PRODUCT DISPOSAL
Used pressure washers should not be disposed of with
household waste. This product contains electric compo-
nents that should be recycled. Please take this product to
your local recycling facility for responsible disposal and to
minimize its environmental impact.
Fig. 12
Fig. 13
1
17