Replacement Part List

WARNING! Only separate the high pressure hose from the spray gun or the device when there is no pressure
in the system.
CAUTION! When disconnecting the supply or high pressure hose, warm water may leak from the connection
after operation.
5. Turn off the water supply, then detach the pressure washer from the water supply.
OPERATION
PRESSURE WASHING TIPS
1. Before pressure washing any surface, test spray an inconspicuous area. Adjust the spray pattern and spraying
distance to achieve the optimal cleaning result and prevent damaging the surface.
2. Use caution when spraying chipped or peeling paint, as the high pressure may remove the loose paint from the
surface.
3. Pre-rinse the surface with fresh water before applying detergent.
4. When using detergent, follow the instructions that come with your detergent. In general, allow the detergent to
remain on the surface about 1 - 3 minutes. Do not allow detergent to dry on the surface.
5. Keep the spray nozzle approximately 6 inches from the cleaning surface. The spraying distance may vary accord-
ing to the treated surface (be sure to increase the distance when rinsing sensitive or fragile surfaces). Rinse the
surface in a long sweeping motion.
6. Clean from top to bottom. When moving on to a new section of the cleaning surface, overlap the previous section
to eliminate stop marks and ensure a more even cleaning result.
7. When pressure washing surfaces that may come in contact with food, flush surfaces with plenty of drinking water
after pressure washing. However, WEN does not recommend eating off of your driveway.
TURNING OFF THE PRESSURE WASHER
1. Release the power trigger.
2. Turn the power switch OFF.
3. Unplug the pressure washer from the power outlet.
4. Press the trigger gun to release any pressure still in the high pressure hose.
15