Instruction Manual

CARBON BRUSH REPLACEMENT
The wear on the carbon brushes depends on how frequently and
how heavily the tool is used. If you see excessive sparks during
operation or if the tool stops working, inspect the brushes and
replace them.
Replacement carbon brushes (Part No. 6362-040) can be ordered
from wenproducts.com. Only genuine WEN replacement brushes
designed specifically for your tool should be used.
1. To inspect the brushes, open the carbon brush covers (Fig. 7 -
1) by turning them counterclockwise with a flat-head screwdriver
(not included).
2. Take out and inspect the carbon brushes (Fig. 8). If the brush-
es are worn to under 1/8 inch in length, replace them with new
carbon brushes. Both carbon brushes should be replaced at the
same time.
3. Reinstall the brush caps.
PRODUCT DISPOSAL
Used power tools should not be disposed of together with house-
hold waste. This product contains electronic components that
should be recycled. Please take this product to your local recy-
cling facility for responsible disposal and to minimize its environ-
mental impact.
Fig. 7
Fig. 8
1
1
Carbon
Brush
Length
13
MAINTENANCE
WARNING! To avoid accidents, make sure the power switch is in the OFF position and unplug the tool from
the electrical outlet before cleaning or performing any maintenance. Servicing of the tool must be performed by
a qualified technician.