Instruction Manual

ASSEMBLY & ADJUSTMENTS

ATTACHING THE AUXILIARY HANDLE

For safe operation, the auxiliary handle must be installed.

The handle can be assembled onto either side of the tool,

depending on your preference. Thread the handle into

the mounting hole (Fig. 1 - 1) and turn it clockwise to

tighten. Make sure the handle is securely mounted.

When operating the tool, hold on to the main handle and

auxiliary handle to prevent loss of control.

ATTACHING AND CHANGING SANDING DISCS

Your tool comes with 150, 180, 240 and 400 grit sand-

ing discs for different sanding requirements.

Attach the sanding disc of your choice to the center of

the hook and loop base pad. The holes in the sanding

disc must align with the dust extraction hole in the base

pad (Fig. 2).

Replacement sanding discs can be ordered from wen-

products.com.

ATTACHING THE DUST HOSE

Align and insert the dust port connector (Fig. 3 - 1) all

the way onto the dust port on the back of your sander

(Fig. 3 - 2). The dust hose is connected to a dust bag to

collect dust during sanding operations.

CONNECTING TO A DUST EXTRACTOR

Alternative to using the dust bag, you can also connect

your sander to a dust extractor. Your sander comes with

three sizes of adapters, a 1-7/8-inch adapter, a 1-1/4-

inch adapter (located inside the 1-7/8-inch adapter), and

a 2-1/4-inch adapter.

Connect the dust hose to a suitable adapter and connect

it to the dust extractor of your choice.

NOTE: Your sander comes with a 7.5-feet dust hose to

allow ease of use with the dust bag. If you need a longer

hose, a 15-feet dust hose is available for purchase from

wenproducts.com.

WARNING! To prevent injury from accidental operation, make sure the tool is switched OFF and unplugged

from the power source before assembling the tool or making any adjustments.

Fig. 1

Fig. 2

Fig. 3

1 UNLOCKED

LOCKED