Use and Care Manual

2322
TROUBLESHOOTING GUIDE
PROBLEM CAUSE SOLUTION
Excessive noise
or vibration
Blade is installed improperly Ensure blade is installed in correct orientation.
Blade is damaged Replace blade.
Blade is not secure
Make sure the blade flanges are flush against the blade and
arbor bolt is tightened completely.
Cutting too fast
Do not force the tool. Let it work at its own pace. Ensure blade
selection is appropriate for cut type and workpiece.
Worn bearings
Stop using the tool and call 1-800-232-1195 for customer
service.
Blade will not
turn
Spindle lock engaged
Disengage the spindle lock; move blade back and forth to
ensure it is disengaged.
Worn bearings
Stop using the tool and call 1-800-232-1195 for customer
service.
Defective gears
Stop using the tool and call 1-800-232-1195 for customer
service.
Saw will not
plunge
Plunge button not pressed, or not
pressed all the way
Ensure plunge button is fully pressed before beginning plunge.
Incorrect plunge mode selected Select correct plunge mode (see page 13).
Broken plunge linkage
Stop using the tool and call 1-800-232-1195 for customer
service.
WARNING: Stop using the tool immediately if any of the following problems occur. Repairs and replace-
ments should only be performed by an authorized technician. For any questions, please contact our customer
service at [phone], M-F 8-5 CST or email us at [e-mail].
MAINTENANCE
WARNING: To avoid accidents, turn OFF and
unplug the tool from the electrical outlet before
cleaning, adjusting, or performing any maintenance
work.
WARNING: Any attempt to repair or replace
electrical parts on this tool may be hazardous. Ser-
vicing of the tool must be performed by a qualified
technician. When servicing, use only identical WEN
replacement parts. Use of other parts may be haz-
ardous or induce product failure.
ROUTINE INSPECTION
Before each use, inspect the general condition of the
tool. If any of these following conditions exist, do not
use until parts are replaced or the saw is properly re-
paired.
Check for:
• Loose hardware,
• Misalignment or binding of moving parts,
• Damaged cord/electrical wiring,
• Cracked or broken parts, and
• Any other condition that may affect its safe operation
Maintenance information continues on the next page.