Use and Care Manual

1514

NOTE: The track, track adapters, clamps, and 3mm hex wrench are not included. These items can be purchased

separately at wenproducts.com.

Fig. 9

ASSEMBLY & ADJUSTMENTS

2. Follow step "2.1" if you are using the track, follow step

"2.2" if you are not using the track.

2.1) When using the saw with the track, always align

position A (the "0" mark on the base plate) with your

marked cutting line.

2.2) When using the saw without the track, align posi-

tion A (the "0" mark on the base plate) with your

marked cutting line for straight cuts. Align posi-

tion B (the "45" mark on the base plate) with your

marked cutting line for 45° bevel cuts.

NOTE: Since blade thicknesses vary, it is necessary to

make test cuts along a guide line on a piece of scrap ma-

terial to determine the proper alignment of the guideline

within the notch. This will help to obtain an accurate cut

with blades of various thicknesses.

SETTING UP THE TRACK

NOTE: You will need to remove the protective sleeves

from the ends of each track before using the track. To

help your saw glide smoothly along the track, do not

allow dust, shavings, or other debris to build up on the

track.

1. Each track adapter assembly is made up of 6 pieces:

a spacer, a sleeve, and four hex screws. Assemble the

track adapter by fitting the spacer into the sleeve, op-

posite the hex screws. See Fig. 8.

2. Slide the track adapter assembly into the groove on

the front face of the track. Half of the adapter should be

in the groove and half should hang off the track. The

hex screws should be accessible. Tighten the two hex

screws that are within the track with a 3mm hex wrench

(Fig. 9).

3. Repeat step 2 with the second adapter and the groove

on the underside of the track. Be sure to tighten the two

hex screws that are within the track.

Instructions continue on the next page.

Fig. 8

Fig. 7

Track Adapter Assembly

Spacer

Hex Screws

Sleeve

Track