Use and Care Manual

ASSEMBLY & ADJUSTMENTS

WARNING! Unplug the machine from the power source before assembly and making adjustments. Failure

to comply may cause serious injury. Assembly requires at least two people to safely move around the band saw.

ASSEMBLING THE TABLE

1. Remove the M6x24 hex bolt, spring washer, ﬂat washer and wing

nut from the work table assembly (Fig. 2).

2. Slide the saw table onto the band saw, making sure that the blade

stays within the slot in the table (Fig. 3).

3. Pull the angle adjustment knob (Fig. 4 - 1) on the back of the band

saw and align the teeth on the table bracket into the teeth on the

angle adjustment knob. Release the knob.

3. Assemble the ﬂat washers and table lock knobs (Fig. 4 - 2) into the

table bracket. Turn the table lock knobs to tighten the table assembly

to the saw’s frame.

4. Reattach the hex bolt, spring washer, ﬂat washer and wing nut

onto the front of the table (Fig. 2).

TILTING THE TABLE

1. Loosen the two table lock knobs located on the back of the band

saw (Fig. 4 - 1).

2. Adjust the table to the desired angle using the angle adjustment

knob (Fig. 4 - 2) and the angle indicator. The table can be tilted 45

degrees to the right.

3. Use the angle indicator to conﬁrm the desired angle and tighten

the table lock knobs.

NOTE: A table perpendicular to the blade corresponds to a scale in-

dication of 0°.

MOUNTING THE BAND SAW

The band saw should be ﬁrmly attached to a reliable work surface.

This will prevent the band saw from vibrating, walking or tipping dur-

ing operation. Mount your band saw using bolts, ﬂat washers, lock

washers and hex nuts (not included) through the mounting holes on

the base of the saw (Fig. 5 - 1).

CONNECTING TO THE DUST COLLECTION

Connect your band saw to the dust collection system of your choice

(not included) using the dust port on the back of the unit (Fig. 5 - 2).

The outer diameter of the port is 2-1/2 inches. Hose adaptors (not

included) may be needed depending on the size of your dust hose.

NOTE: Always operate in a well-ventilated area and use dust collec-

tion systems whenever possible.

Fig. 2

Fig. 3

Fig. 4

Fig. 5