Use and Care Manual

PROBLEM CAUSE SOLUTION
Sander does
not turn on.
1. Power cord or extension cord dam-
aged or not properly plugged in.
1. Check the power cord, extension cord, power plug
and the power outlet. Make sure the tool is properly
plugged in. Do not use the if any cord is damaged.
2. Safety key is removed from power
switch.
2. Insert the safety key into the power switch.
3. Defective power switch, defective
motor or wiring, short circuit or loose
connections.
3. Stop using the tool and contact customer service at
1-[phone], M-F 8-5 CST for assistance. Repairs
must be done by a qualified technician.
4. Circuit breaker is tripped. 4. Push circuit breaker to reset.
5. Worn carbon brushes. 5. Replace carbon brushes.
Motor
overheats.
1. Motor overloaded.
1. Reduce load on motor - reduce pressure on the work-
piece being sanded.
2. Extension cord too long with an insuf-
ficient gauge.
2. Utilize an extension cord of appropriate gauge and
length or plug tool directly into outlet (see page 8).
3. Dust collection not being used. 3. Use dust collection.
Sanding grains
easily rub off.
1. Sanding sleeve has been stored in an
incorrect environment.
1. Store sanding accessories away from extremely hot/
dry temperatures.
2. Sanding sleeve has been damaged or
folded.
2. Store sanding accessories flat—not bent or folded.
Deep
sanding
grooves or
scars in
workpiece.
1. Sanding sleeve grit is too coarse for
the desired finish.
1. Use a finer-grit sanding accessory.
2. Workpiece sanded across the grain. 2. Sand with the grain of the wood.
3. Too much sanding force. 3. Reduce pressure on workpiece while sanding.
4. Workpiece held still against sanding
surface for too long.
4. Keep workpiece moving while sanding on the sanding
sleeve.
TROUBLESHOOTING GUIDE
WARNING! Stop using the tool immediately if any of the following problems occur. Repairs and replace-
ments should only be performed by an authorized technician. For any questions, please contact our customer
service at 1-[phone], M-F 8-5 CST or email us at [e-mail].
15