Use and Care Manual

Hardware & Tools
Accessories
Before using the spindle sander, you must configure the machine by installing the appropriate sanding drum, sand-
ing sleeve, throat plate and spindle washer for your operation. Check your packing list against the diagram below.
If any part is damaged or missing, please contact our customer service at 1-[phone], M-F 8-5 CST or email
us at [e-mail].
PACKING LIST
Spindle Nut
Wrench
Spindle with
Lock Nut
ASSEMBLY & ADJUSTMENTS
(13 mm)
1/2"
(19 mm)
3/4"
(26 mm)
1"
(38 mm)
1-1/2"
(51 mm)
2"
(76 mm)
3"
NOTE: 1/2" sanding sleeve
fits directly on the spindle.
Rubber Sanding Drums (5)
80-Grit Sanding Sleeves (6)
Sanding Throat Plates (6)
Upper Spindle Washer Size
Small
Medium Large
10
Upper Spindle Washer (3)
L
S M
Lower Spindle Washer (1)
Locking
Washer (1)