Product Manual

Fig. 3

ASSEMBLING THE SERVICE CART (CONT.)

5. Now for the lower tray (Fig. 3 - 1). Turn the shelf tray

upside down and place it onto the four legs (Fig. 3 - 2).

The ﬂanges on the four legs should ﬁt into the depres-

sions in this shelf tray. If all 12 screws were correctly se-

cured through the four legs into the shelf tray, everything

should ﬁt together. Gently tap shelf tray onto the four legs

until the tabs and shelf tray depressions are in contact

with each other.

6. Insert the carriage bolts (Fig. 4 - 1) up through the leg

tabs and the shelf tray. Attach the casters (Fig. 5 - 1) by

ﬁrst hand tightening the washers (Fig. 5 - 2) and nuts (Fig.

5 - 3). Once all four casters are in place, go back and use

an adjustable wrench to make sure all nuts and bolts are

fully tightened and secure.

NOTE: To maximize control, we suggest installing the

ﬁxed casters on the same side as the handle, while the

swivel casters go on the opposite side of the cart. How-

ever, if you prefer to have them the opposite way in order

to make sharper turns and pivots, that will also work.

7. Turn service cart upright and install the towel rack (Fig.

6 - 1). Make certain all hardware is tight and that the cast-

ers roll properly before adding any weight onto the cart.

ASSEMBLY & ADJUSTMENTS

Fig. 4

Fig. 5

Fig. 6