Product Manual
FILLING/EMPTYING THE WATER RESERVOIR (Figs. 10 & 11)
1. Remove the bevel table to access the water reservoir. Push down firmly on the water drain plug (Fig. 11 - 1) to
avoid water from leaking out.
2. Fill the water reservoir with water up to the maximum fill line marked on the inside of the reservoir (Fig. 10). Do
not add chemicals or detergents to the water.
To empty the reservoir water:
1. After operation, turn off the tool and disconnect the power supply. Place the water reservoir drain hole over a
container large enough to hold the water. Pull out the water drain plug (Fig. 11 - 1) and drain the waste water. Do not
allow water to splash onto the ground or around machine. Discard waste water in accordance with local regulations.
2. Clean the water reservoir after each use to avoid build-up.
ASSEMBLY
WARNING: To prevent serious injury from accidental operation, make sure the power cord is discon-
nected from the power source and the tool is switch to OFF before assembly or making any adjustments.
11
▲
REPLACE THE BEVEL TABLE
Fix the bevel table to main table, set the two legs between the pins and the wall of water reservoir.
Tilt the bevel table to the horizontal position.
OPERATING INSTRUCTIONS
Always draw the line to be cut on the tile using a marker
or
grease pencil. If the tile is shiny and hard-to-mark,
place
masking tape on the tile and mark the
tape.
A common problem when cutting tile is straying from
the
marked
line.
Once you’ve strayed from the mark,
you can
no
t
force the wheel back to the line by twisting the tile. Instead, back up and recut the tile slicing off a
small amount of
tile
until the wheel is back on
track.
To avoid this problem, use the rip guide when making
cr
oss
cuts, the miter guide for miter cuts and the bevel
table
for
making bevel cuts, whenever
possible.
Another problem is cutting difficult material. To prevent
chip
ping of the material at the end of the cut: first cut
1-1/2 in. of the material then turn off the saw; flip the material
ar
ound
180º and make the
cut.
Clean the saw table, rip and miter guides, and bevel
table
frequently during use. Debris from the cut
Pin
Leg
Wall
Fig. 10 Fig. 11
Max Fill Line
1
CAUTION: Do not operate the tile saw with too little or too much water in the water reservoir. Make sure there
it enought water to cool the cutting wheel as it rotates.
14