Product Manual

ManualsBrandsWEN ManualsBenchtop6.5A 7-Inch Portable Wet Tile Saw with Fence and Miter Gauge

INSTALLING THE RIP GUIDE (Fig. 8)

1. Place the rip guide (Fig. 8 - 1) onto the saw table, with the locking lever (Fig. 8 - 2) in the unlocked (raised) posi-

tion.

2. Refer to the rip guide scale on the front and rear of the table and set the rip guide to the desired width of cut.

3. Push the locking lever (Fig. 8 - 2) down to secure the rip guide onto the saw table.

NOTE: If the rip guide is loose, tighten the 6mm nut on the end of the guide (71707-071), and try again. Make

adjustments to the nut as necessary.

INSTALLING THE MITER GUIDE (Fig. 9)

1. Slide the miter guide onto the rip guide.

2. The miter angle can be adjusted from 0° to 45°. Loosen the miter guide knob (Fig. 9 - 1) and rotate the guide to

the desired angle. Tighten the miter guide knob to lock the miter guide’s angle.

WARNING: To prevent serious injury from accidental operation, make sure the power cord is discon-

nected from the power source and the tool is turned OFF before assembly or making any adjustments.

ASSEMBLY

▲

INSTALLING THE RIP GUIDE AND MITER GUIDE

1. Place the rip guide on the saw

table.

2. Use the rip guide scale, located on front and rear of the table,

set the rip guide to the desired width of

cut.

3. Push the locking lever down to secure to the saw

table.

4. Align the male dovetail under the miter guide with the dovetail

oove in the top of the rip

guide.

5. Push the miter guide onto the rip guide to the desir

operating

position

▲FILLING/CHANGING THE

WATER

RESERVOIR

Fill the water reservoir with clean tap water. Do not try to fill the water upper than max fill line. The water will

overflow from the overflow drain.

2. To change reservoir

water:

Unplug the saw.

Remove

the overflow drain and empty waste water into a bucket. Do not allow the water

to splash onto the

ound

or around the machine. Rinse the machine

thor

oughly

Discard the waste water in

accordance with local r

egula

tions.

Firmly push the overflow drain into the hole in the

bottom

of the water fill

reservoir. Replace

with clean

water

Fig. 8 Fig. 9