Product Manual

ManualsBrandsWEN ManualsBenchtop6.5A 7-Inch Portable Wet Tile Saw with Fence and Miter Gauge

WARNING: To prevent serious injury from accidental operation, make sure the power cord is discon-

nected from the power source and the tool is turned OFF before assembly or making any adjustments.

ASSEMBLY

INSTALLING THE BLADE GUARD (Figs. 6 & 7)

1. Slide the blade guard bracket (Fig. 6 - 1) into the lip under the table behind the cutting wheel. Align the two slots

of the blade guard bracket with the two flat head screws (Fig. 6 - 2). Position the blade guard bracket between the

tabletop and the locking plate.

2. Position the bracket so that it is parallel with the cutting wheel. Using a Phillips head screwdriver (not included),

tighten the two flat head screws to secure the blade guard bracket in place.

3. Slide the blade guard over the bracket, align the holes (Fig. 7 - 1) in the blade guard with the slot in the blade

guard bracket.

4. Insert the hex bolt (Fig. 7 - 2) through the blade guard and bracket, and thread the knob (Fig. 7 - 3) onto the bolt.

Set the blade guard to the desired height and tighten the knob.

NOTE: Do not over-tighten the protective guard. The guard should rise and fall freely as the workpiece is pushed

towards the wheel during cutting operation. Ensure the protective guard cannot touch the cutting wheel.

NOTE: Before each operation, check the blade guard height to make sure it sits slightly above the tile. Adjust the

height if necessary. This will provide the maximum protection.

▲

INSTALLING THE RIP GUIDE AND MITER GUIDE

1. Place the rip guide on the saw

table.

2. Use the rip guide scale, located on front and rear of the table,

set the rip guide to the desired width of

cut.

3. Push the locking lever down to secure to the saw

table.

4. Align the male dovetail under the miter guide with the dovetail

oove in the top of the rip

guide.

5. Push the miter guide onto the rip guide to the desir

operating

position

▲FILLING/CHANGING THE

WATER

RESERVOIR

Fill the water reservoir with clean tap water. Do not try to fill the water upper than max fill line. The water will

overflow from the overflow drain.

2. To change reservoir

water:

Unplug the saw.

Remove

the overflow drain and empty waste water into a bucket. Do not allow the water

to splash onto the

ound

or around the machine. Rinse the machine

thor

oughly

Discard the waste water in

accordance with local r

egula

tions.

Firmly push the overflow drain into the hole in the

bottom

of the water fill

reservoir. Replace

with clean

water

Fig. 6

Fig. 7