Use and Care Manual

ASSEMBLY AND ADJUSTMENTS

SQUARE THE FENCE

1. Place a combination square (not included) against the face of the fence and the table surface. The

fence and table must be at a 90° angle to each other. If not, loosen the fence bevel handle (Fig. 3 - 2)

and the hex nut (Fig. 4 - 5) and turn the bolt (Fig. 4 - 6) with a screwdriver until the fence is square.

Secure it back in position by tightening the hex nut (Fig. 4 - 5).

2. Use a combination square (not included) to check the 45° limit stops. The 45° inward stop (Fig. 4 -

1) is the hex head bolt located beneath the shaft. The 45° outward stop (Fig. 3 - 4) is centered at the top

of the backside of the fence (Fig. 3 - 1). If adjustments are needed, loosen the hex nut on either stop,

turn the hex head bolt to the proper position, and secure in place again with the hex nut.

Fig. 6

Fig. 5

INSTALL THE DUST CHUTE

1. Slide the dust chute (Fig. 5 - 1) onto the end of the chip ex-

haust (Fig. 5 - 2).

2. Tighten the Phillips-head screw (Fig. 5 - 3) to secure the dust

chute on the chip exhaust.

INSTALL THE FILTER BAG

The filter bag is designed to provide dust collection for wood-

working tools using the 2-1/2” diameter dust port. The filter bag

operates as an easy, convenient sawdust collection and disposal

system. To install:

1. Open the zipper on the bottom of the bag (Fig. 6 - 4) and place

the spring (Fig. 6 - 3) inside of the filter bag spout

(Fig. 6 - 1). The smaller end should come out of the spout first.

2. Slide the filter bag spout with the spring inside of it over the

dust chute (Fig. 6 - 2). Securely press the smaller end of the

spring over the opening of the dust chute.

ADJUST THE INFEED TABLE

The infeed table has been pre-set from the factory to be level.

However, if you find it is not level, adjust it using the procedures

below. You will need:

• A Phillips-head screwdriver (not included)

• Hex wrenches (M5 and smaller)

Instructions begin on the next page.