Use and Care Manual

Fig. 3
Fig. 2
Fig. 4
ASSEMBLY AND ADJUSTMENTS
10
WARNING: Do not plug in or turn on the tool until it is fully assembled according to the
instructions. Failure to follow the safety instructions may result in serious personal injury.
ATTACH THE FENCE SUPPORT ASSEMBLY
1. Attach the fence support (Fig. 2 - 3) to the jointer with the
socket head bolts and lock washers.
2. Insert the locking plate assembly (Fig. 2 - 4) into the support.
Position the plate so that the upper edge of the curved surface
of the pins (Fig. 2 - 5) are against the bottom edge of the sup-
port. The dovetail at the top of the plate should protrude through
the slot in the fence support (Fig. 2 - 3).
3. Secure the plate in position with the fence sliding handle (Fig.
2 - 1) and the spacer (Fig. 2 - 2).
ATTACH THE FENCE & FENCE BRACKET
1. Attach the fence (Fig. 3 - 1) to the fence bracket assembly
(Fig. 3 - 3) with four socket head bolts and lock washers.
2. Slide the fence and bracket assembly onto the dovetails of the
support (Fig. 3 - 5) and the locking plate (Fig. 2 - 4).
3. Continue to slide the fence forward so that the fence is over
the jointer’s table and the blade guard (Fig. 3 - 6) rests against
the fence. The entire width of the cutterhead should still be cov-
ered by the blade guard. Secure the bracket in position by tight-
ening the fence sliding handle (Fig. 2 - 1).
4. Insert the fence bevel handle (Fig. 3 - 2) with a washer through
the hole in the left link. Tighten it into the threads of the hole in
the right link.
5. Make sure the limit plate (Fig. 4 - 3) is resting in the slot of
the block (Fig. 4 - 4). Position the fence against the bolt (Fig.
4 - 2) and lock the fence in position with the fence bevel handle
(Fig. 3 - 2).
1
2
2
3
3
1
4
5
6
4
NOTE: you may need to loosen the fence sliding handle
(Fig. 2 - 1) in order to align the dovetails.
S
1fi
借(通)用件登记
爆炸图序号
机 种
旧底图总号
底图总号
签 字
日 期
区
1
2
3
4 5
6