Use and Care Manual

TROUBLESHOOTING

ADJUSTING INFEED/OUTFEED EXTENSION TABLE

We recommend setting your infeed and outfeed tables so that the ends of the table extensions are approximately

1 to 2 mm above the top of the granite table.

1. Locate the table elevation adjustment screw and nut on both sides of the planer, next to the hinge (Fig. 18).

2. Raise the extension table to expose the screws (Fig. 19).

3. Using two 10 mm crescent wrenches or a suitable Phillips screwdriver, loosen the screw by holding the nut with

a crescent wrench and turning the screw head counterclockwise.

NOTE: Keep track of the number of turns you apply to each screw. Make sure that both the left- and right-hand

screws on the table are turned the same number of times.

4. When both screws are adjusted to the height you want the table to be, tighten down the nut against the base of

the planer by holding the screw head with a crescent wrench or Phillips screwdriver and turning the nut clockwise.

Repeat for the other screw.

5. Test the table height. If adjustments need to be made, repeat steps 3 to 4 as needed, ensuring that both screws

have been turned the same number of times.

6. Repeat steps 1-5 on the other table until you are satisfied with the height.

7. Test the adjustments on a scrap piece of wood, making further adjustments as necessary until you are satisfied.

Fig. 18

Fig. 19