Use and Care Manual

OPERATION

DUST COLLECTION (Fig. D)

WARNING: This machine creates a lot

of dust. Inhaling said dust on a regular

basis can cause permanent respiratory ill-

ness. Minimize your exposure by wearing

a respirator and using a dust collector.

To connect a dust collection system to the machine:

1. Fit a 1-1/2 in. dust hose over the dust port and

secure in place with a hose clamp as needed.

2. Tug the hose to make sure that puppy is tight. A

tight fit is necessary for proper performance.



Fig. D

INITIAL TEST RUN

WARNING: This machine creates a lot of dust. In-

haling said dust on a regular basis can cause perma-

nent respiratory illness. Minimize your exposure by

wearing a respirator and using a dust collector.

Once assembly has been completed, run the ma-

chine to ensure proper connection.

1. Clear all setup tools away from the machine.



Fig. E

2. Connect the machine to a power supply.

3. Turn the machine ON to make sure the motor runs correctly. Once verified, turn the machine OFF. The mo-

tor should run smoothly without any unusual problems or noises.

4. Remove the red safety tab and try to start the machine (Fig. E). The sander should not power up without this

tab.

Once all of these steps have been checked and completed, the sander is ready for operation.