Use and Care Manual

ASSEMBLY



ASSEMBLY

WARNING: To avoid injury from accidental startups, turn switch OFF and remove the plug from the power

source outlet before making any adjustments.

Place the spindle nut, table inserts, sanding drums, sanding sleeves, spindle washers, belt-sanding attachment and

spindle nut wrench in the appropriate storage slots beneath the table (Fig. A & Fig. B). A sanding drum does not

need to be installed until after the initial test startup.



Fig. A

Fig. B

MOUNTING THE UNIT

The base of this machine has four 1/4 inch mounting holes on the corners of the base. Mount to a benchtop sur-

face to maximize safety and minimize vibration, walking, tipping and wobbling.

The strongest mounting option is a through mount, where the bolts go all the way through the work surface (Fig.

C). The other option would be a direct mount, where the sander maintains stability using screws that go directly

into the work surface (Fig. D).



Fig. C

Fig. D