Use and Care Manual

7
KNOW YOUR BELT & SPINDLE SANDER

A - Work Table
B - Sanding Belt
C - Belt Tracking Adjustment Knob
D - Belt Tensioning Lever
E - Work Stop
F - Spindle
G - Spindle Nut
H - Sanding Drum w/ Sleeve
I - Table Insert
J - Dust Port
K - Throat Plate Storage
L - Table Tilt Locking Knob
M - ON/OFF Switch
N - Sanding Drum Storage
UNPACKING
A - Belt Sanding Attachment
B - 80-Grit Sanding Belt (4 x 24 in.)
C - Spindle Nut Wrench (13 mm)
D - Sanding Drums (3/4, 1, 1-1/2, & 2
in.)
E - 80-Grit 4-1/2 in. Sanding Sleeves
(1/2, 3/4, 1, 1-1/2, & 2 in. diameter)
F - Table Insert
G - Throat Plates (1/2, 3/4, 1, 1-1/2, &
2 in.)
H - Spindle Washers (5/8, 7/8, & 13/4
in. outer diameter)
I - Hex Nut (M8 - 1.25)
