Use and Care Manual

ADJUSTMENTS

REPLACING THE ABRASIVE SANDING DISC

1. Remove the disc table and the disc dust chute.

2. Remove the used sanding disc by peeling it from the aluminum base disc. A WEN 2020 Heat Gun can help to

soften up the adhesive to make for an easier, cleaner removal.

3. Wipe the aluminum base disc clean if necessary.

4. Peel the backing from the new sanding disc, align the disc with the plate and press the sanding disc firmly on to

the plate.

5. Reinstall the dust chute and work table.

ADJUSTING THE DISC TABLE ANGLE

1. The disc table can be adjusted from 0 to 45 degrees for

sanding beveled work. To adjust the disc table, loosen the

two lock handles (Fig. I - 3) and pivot to the desired angle.

2. Use the scale (Fig. I - 2) on the disc table to set the table

from 0 to 45 degrees from the abrasive disc.

3. When the disc table is at the desired angle, lock it into

position by securely tightening the handles.

Fig. I

MAINTENANCE

WARNING: For your own safety, turn the switch OFF and remove the plug from the electrical outlet before

adjusting or performing maintenance or lubrication work on the belt/disc sander.

Before using, check to make sure parts are not damaged, missing, or worn. Check for alignment of moving parts,

binding of moving parts, improper mounting, or any other conditions that may affect the sander operation. If any

of these conditions exist, do not use the sander until parts are replaced or the sander is properly repaired. Fre-

quently blow or vacuum dust from all sanding parts and motor housing.

WARNING: Any attempt to repair or replace electrical parts on this tool may be hazardous. Repairs should be

done by a qualified service technician.

ADJUSTING THE BELT TABLE ANGLE

1. The belt table can be adjusted from 0 to 45 degrees for

sanding beveled work. To adjust the belt table, loosen the

lock handle (Fig. I - 4) and pivot to the desired angle.

2. Use the scale (Fig. I - 5) on the belt table to set the table

from 0 to 45 degrees from the abrasive belt.

3. When the belt table is at the desired angle, lock it into

position by securely tightening the handle.