Use and Care Manual

ASSEMBLY

ASSEMBLE THE BELT TABLE AND DUST CHUTE

1. To move the table from the horizontal to the vertical position, loosen the lock handle (Fig. E - 1) that threads into

the pivot bracket (Fig. F - 1). Tilt the belt assembly to the vertical position in order to install the table. Secure the

belt assembly in position by retightening the lock handle in the pivot brackets. The lock handle is spring-loaded and

can be re-positioned as needed by pulling the handle outwards and adjusting it appropriately.

2. Slide the belt table assembly into the trunnion groove in the pivot bracket. Mount it in place using the lock handle

and a flat washer. Place the table in the desired position. Be sure that the gap between the belt and the table is 1/16

of an inch or less. Tighten the lock handle securely.

3. Mount the belt dust chute to the plate using two pan head screws and flat washers.

Fig. E Fig. F

ADJUST THE BELT WORK TABLE

1. Place a combination square (not included) (Fig. G

- 1) on the belt work table so that it also touches the

sanding belt.

2. If the table is not 90 degrees with the belt, loosen

the lock handle (Fig. G - 3) and tilt the table. Re-tight-

en the lock handle to secure the table.

3. Loosen the angle pointer screw (Fig. G - 2) and ad-

just it. Retighten screw.

Fig. G

ADJUSTMENTS