Use and Care Manual

ASSEMBLY AND ADJUSTMENTS

INSTALLATION OF SANDING DISC AND GUARD

1. Peel backing away from sanding disc.

2. Align perimeter of disc with plate, and press disc firmly

into position on plate, leaving no loose edges.

3. Position disc guard against lower 1/3 of disc, aligning

holes as shown. And use a screwdriver to fasten the provided

screws and washers securely.

MOUNT THE DISC SANDER TABLE

1. With the table in a horizontal position, line up and insert the pivot indexing pin with the pivot hole on the frame.

Hold in place.

2. Insert the handle into the threaded hole and tighten.

3. Adjust the table so that the edge is a maximum of 1/16 inch from the disc.

NOTE: If needed, make minor adjustments to the position of the table by loosening the three bolts that appear on

the underside of the table. Once the desired clearance is achieve, retighten these three bolts.

WARNING: To avoid trapping the workpiece or fingers between the table and the sanding disc, the

table edge should be adjusted to a maximum of 1/16 inch from the sanding disc.

