Use and Care Manual

KNOW YOUR BELT/DISC SANDER

ASSEMBLY AND ADJUSTMENTS

UNPACKING

WARNING: To avoid injury from accidental startups, turn switch OFF and remove the plug from the

power source outlet before making any adjustments.

Carefully unpack the belt/disc sander and all its parts, and compare against the list below. Do not discard the

carton or any packaging until the belt/disc sander is completely assembled.

INCLUDES (Fig. 1)

1. Socket Head Screws (2)

2. Miter Gauge (1)

3. Washers (2)

4. Work Support (1)

5. Hex Key 15/64” (1)

6. Worktable (1)

7. Adjustment Knob (1)

Work Support

Belt Tension

Lever

Belt Sanding

Area

Tracking

Control Knob

Miter

Gauge

Work Table

ON/OFF

Switch

Base Bolt

Holes

Dust

Port

Table Angle

Adjustment Knob

Drive

Drum

Sanding

Disc