Use and Care Manual

ASSEMBLY AND ADJUSTMENTS

FEET INSTALLATION (Fig. B)

1. Carefully set the belt sander on its side.

2. Find the four rubber feet (Fig. B - 1) in the parts bag.

3. Press-fit each rubber foot over the lip of the corners around the

base of the machine.

MOUNT THE DISC SANDER TABLE

1. Install the support rod (Fig. D - 2) into the hole on the body

below the sander’s disc. Make sure the flat surface of the rod is

oriented in the vertical position and is securely tightened in place

using two set screws.

2. Slide the pivot bracket (Fig. D - 3) all the way onto the rod and

tighten the set screw.

3. The table can also be installed to the support block (Fig. E - 1)

beside the body for the vertical belt sanding operation.

MOUNTING THE ALUMINUM DISC (Fig. C)

1. Place the belt sander so that it is sitting on its feet.

2. Loosen the disc’s set screw (Fig. C - 2) with a hex wrench (Fig.

C - 1).

3. Slide the disc all the way onto the drive shaft so that the set screw

faces the shaft’s flat surface.

4. Securely tighten the set screw.

Fig. B

Fig. C

Fig. D

Fig. E