Use and Care Manual

Loading the fasteners

Caution: Always disconnect the tool from the air supply before loading the fasteners.

1. Depress the lock to release the movable magazine and pull

the magazine out fully.

2. Place a full clip of the specified type and size fasteners on the

fixed magazine, up to 100 fasteners may be loaded in the

magazine.

3. Push the movable magazine forward until it was locked.

Actuating tool

Warning: To reduce the risk of injury, Always wear proper eye and hearing protection when

operating this tool.

Warning: A nail will fire each time the trigger is depressed as long as the contact trip remains

depressed which could result in inadvertent actuation.

1. Depress the contact trip firmly against the work surface.

2. Depress the trigger.

Adjusting depth

Warning: To reduce risk of serious injury from accidental actuation when attempting to adjust

depth, ALWAYS:

• Disconnect air supply.

• Avoid contact with trigger during adjustments.

The depth that the fastener is driven can be adjusted using the depth adjustment next to the trigger

of the tool.

1. To drive the fastener shallower, rotate the depth setting wheel (L) to the right.

2. To drive a fastener deeper, rotate the depth setting wheel (L) to the left.