Instruction Manual

AMPERAGE

REQUIRED GAUGE FOR EXTENSION CORDS

25 ft. 50 ft. 100 ft. 150 ft.

.5 A 18 gauge 16 gauge 16 gauge 14 gauge

Guidelines for using extension cords

Make sure your extension cord is in good condition. When using an extension cord, be sure to use one

heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line volt-

age resulting in loss of power and overheating. The table below shows the correct size to be used according

to cord length and nameplate ampere rating. When in doubt, use a heavier cord. The smaller the gauge

number, the heavier the cord.

Make sure your extension cord is properly wired and in good condition. Always replace a damaged exten-

sion cord or have it repaired by a qualified person before using it.

Protect your extension cords from sharp objects, excessive heat and damp/wet areas.

Use a separate electrical circuit for your tools. This circuit must not be less than a #12 wire and should be

protected with a 15 A time-delayed fuse. Before connecting the motor to the power line, make sure the

switch is in the OFF position and the electric current is rated the same as the current stamped on the motor

nameplate. Running at a lower voltage will damage the motor.

WARNING: This tool must be grounded while in use to protect the operator from electric shock.

ELECTRICAL INFORMATION