Replacement Part List



Once both wheels are installed, attach the support

legs to the generator as shown in Figure B. Again,

remove the bolts, slide the legs into place and

allign the two holes.

Reattach the bolts using the 10/13 and the 10/12

mm wrenches.



Finally, flip the generator back to its upright

position and attach the two handles using the 10/13

and the 10/12 mm wrenches. Do not tighten the

handles too much, as this will restrict movement

and will prevent the handles from folding up and

down as needed.

Make sure that the cushioning on the handle tilts

upwards towards the generator when the handles

are in the relaxed position.



Now you are ready to roll. If you have any

questions, comments or concerns feel free to

contact our helpful and friendly customer service

line at 800-232-1195.

Thanks for remembering WEN.