Installation Instructions

10. Using the flat head screwdriver, remove the old jet nozzle and install the new one (refer to
Fig. 11 below). Re-assemble the generator by following the steps above in reverse order.
12. Follow the startup procedures listed in your generator manual to set up and use your
generator.
NOTE: The procedure for installing a high-altitude kit for the WEN 56180 1800W Generator
is very similar. Refer to the procedures above, as well as Figures 12 and 13 below.
Figure 11: Use a flathead screwdriver to remove the old jet and install the new.
Figure 12: The air filter housing can be removed if you so choose.