Use and Care Manual

ASSEMBLY

WARNING: To prevent injury from accidental operation, make sure the tool is switched OFF and un-

plugged from the power source before assembling the tool or making any adjustments.

Fig. 1

Fig. 2

1. Align the handle clutch (Fig. 1 - 1) to the end of the pinion

shaft (Fig. 1 - 2) and fasten using the spring and screw.

2. Installing the handle:

Remove the fasteners pre-attached to the handle. Insert the

end of the handle (Fig. 2 - 1) through the hole on the handle

clutch (Fig. 2 - 2) . Fasten with the spacer, spring, second spacer

and hex nut. Tighten with the wrench or pliers (not included)

STEP 1: CLEAN THE SURFACE

Your tool comes protected with a layer of heavy-duty anti-rust coating. Remove the protective coating from surfaces

using a soft cloth, moistened with kerosene (do not use acetone, gasoline or lacquer thinner).

After cleaning, cover the unpainted surfaces with a layer of good quality household floor paste wax to protect against

rust and corrosion.

STEP 2: INSTALL THE HANDLE (Fig. 1 &2)

Parts needed:

Handle Clutch Spring & Screw

Handle Assembly

(Handle, Big Washer, Spring, Small Washer, Hex Nut)