Use and Care Manual

ASSEMBLY

Hold-down Clamp Hold-down Bar

Tool Holder with Fasteners

Lock Knob

Insert the hold-down bar (Fig. 5 - 1) through the front hole on

the fence rod. Tighten the set screws (Fig. 5 - 2) to secure the

hold-down bar in place.

Slide the hold-down clamp onto the hold-down bar. Tighten

the lock knob to secure the hold-down clamp in position.

Assemble the tool holder (Fig. 6 - 1) onto the back of the mor-

tiser using two screws and two flat washers (Fig. 6 - 2). Tighten

using the included hex wrench.

You can store your wrenches and chisels in the slots of the

tool holder (Fig. 7).

NOTE: Place the chisels with the plastic cap pointing up-

wards to prevent the auger bits from slipping out.

STEP 5: INSTALL THE HOLD-DOWN CLAMP (Fig. 5)

Parts needed:

STEP 6: INSTALL THE TOOL & CHISEL HOLDER (Fig. 6 & 7)

Parts needed:

Fig. 5

Fig. 6

Fig. 7