Use and Care Manual

ASSEMBLY

Fig. 3

Fig. 4

1. Insert the fence assembly (Fig. 4 - 1) through the hole on the guide block (Fig. 4 - 2). Ensure that the set screw on

the top of the fence rod collar is tight.

2. Insert the fence lock handle (Fig. 4 - 3) through the top hole on the fence rod, behind the spring. Tighten the lock

lever to lock the fence in position.

3. Thread the micro-adjustment knob (Fig. 4 - 5) through the bottom hole of the adjustment plate (Fig. 4 - 4). Slide

the micro-adjustment plate onto the fence rod. Using the included hex wrench, tighten the set screw on the side of

the adjustment plate to secure it to the fence rod. Refer to page 14 for adjusting the fence.

Table

Micro-Adjustment

Plate

Micro-Adjustment

Knob

Fence Assembly

(Fence, Rod, Collar, Spring)

Screws

Fence Lock Handle

Assemble the table to the base using two screws. Thread the

screws (Fig. 3 - 1) into the holes of the table and through the

threaded holes on the base.

STEP 3: ASSEMBLE THE TABLE (Fig. 3)

Parts needed:

STEP 4: ASSEMBLE THE FENCE (Fig. 4)

Parts needed: