Product Manual

ASSEMBLY

WARNING! To prevent injury from accidental operation, make sure the tool is switched OFF and unplugged

from the power source before assembling the tool or making any adjustments.

CLEAN THE SURFACE

1. Your tool comes protected with a layer of heavy-duty anti-rust coating. Remove the protective coating from sur-

faces using a soft cloth, moistened with kerosene (do not use acetone, gasoline or lacquer thinner).

2. After cleaning, cover the unpainted surfaces with a layer of good quality household ﬂoor paste wax to protect

against rust and corrosion.

Fig. 2

Fig. 3

INSTALL THE HANDLE

1. Align the handle clutch (Fig. 2 - 1) to the end of the pinion

shaft (Fig. 2 - 2) and fasten using the spring and screw.

2. Installing the handle: Remove the fasteners pre-attached to

the handle. Insert the end of the handle (Fig. 3 - 1) through the

hole on the handle clutch (Fig. 3 - 2) . Fasten with the spacer,

spring, second spacer and hex nut. Tighten with the wrench or

pliers (not included).