Product Manual

OPERATION

WARNING! To prevent serious injury, make sure all the warnings and instructions have been read and un-

derstood before operating this tool.

WARNING! Make sure all bit are sharp and free of damage before using them. Do not use dull or damaged

tools.

OPERATING THE MORTISER

1. Draw cutting guides on the surface of your workpiece. With

the mortiser switched OFF, pull down the handle to lower the

chisel. Adjust the position of the workpiece so the chisel is

aligned with the cutting guide.

2. Adjust the fence so it is right against the back of the work-

piece. Set the depth stop to your desired cutting depth.

3. Install the hold-down clamp (Fig. 17 - 1) to prevent the work-

piece from lifting off the table; make sure you can still slide the

workpiece below the hold-down clamp. Tighten the hold-down

knob (Fig. 17 - 2) to lock the hold-down clamp in place.

TIP: You can place a block of wood between the top of the

headstock and the top plate above the guide columns to short-

en the spindle travel distance for more efﬁcient cutting.

Fig. 17

4. Turn on the mortiser. Wait a few seconds to let the motor reach full speed before feeding the bit into the work-

piece.

5. Make the ﬁrst plunge cut. Go slow and give the chisel plenty of time to cut in and extract the chips. You may want

to plunge in several passes.

6. To make a long rectangular mortise, move the workpiece slightly more than a chisel width along the fence and

make the second cut. Spacing out the cuts allows the chisel to be supported by the wood equally on all four sides. If

the chisel is only support on three sides, it may want to wander in the direction of the open end and create a bend.

7. After the spaced cuts have been made along the width of the rectangle, go back for a second round of cutting

to clear out the spaces between cuts. The resistance will be lower this time, as there is only wood on the front and

back of the chisel.

8. Finally, make a third pass to clear out all waste and achieve a clean cut.

9. Turn off and unplug the machine. Wait for all moving parts to stop completely before cleaning, making adjust-

ments or leaving the work area.