Product Manual

ASSEMBLY

INSTALL THE CHIP GUARD (OPTIONAL)

1. The chip guard can be mounted (optional) to to block ﬂy-

ing chips during operation. Remove the rear screw and nut of

the guard and press it over the quill above the black set screw

(Fig. 10 - 1). Reinstall the screw and nut to secure the guard

in place.

The chip guard is adjustable and can be lifted up out of the way

when necessary. You can also lengthen the guard by loosening

the wing nuts on the sides and sliding the rear guard down,

then re-tightening the nuts.

Fig. 10

PREPARATION & ADJUSTMENTS

USING THE OPERATION HANDLE

The operation handle controls the movement of the head. Pull

down the handle to lower the head.

For maximum leverage, you can reposition the handle by pull-

ing the handle outwards (Fig. 11) and repositioning the handle

clutch on the pinion shaft.

WARNING! To prevent injury from accidental operation, make sure the tool is switched OFF and unplugged

from the power source before assembling the tool or making any adjustments.

Fig. 11