Product Manual

ASSEMBLY

INSTALL THE TOOL & CHISEL HOLDER

Assemble the tool holder (Fig. 7 - 1) onto the back of the mor-

tiser using two screws and two ﬂat washers (Fig. 7 - 2). Tight-

en using the included hex wrench.

You can store your wrenches and chisels in the slots of the

tool holder (Fig. 8).

NOTE: Place the chisels with the plastic cap pointing upwards

to prevent the auger bits from slipping out.

MOUNTING TO A BENCHTOP

For effective and safe operation, the mortiser must be mount-

ed to a secure workbench.

The base of this machine has two mounting holes, each with a

diameter of 1/2” (12 mm). Refer to the base graph (Fig. 9) for

detailed base dimensions of your machine.

The recommended mounting option is “through mounting”,

where a hex bolt is drilled all the way through a ﬂat washer, the

machine base, the workbench, another ﬂat washer, a spring

washer, and tightened with a hex nut. This allows for maximum

stability of the machine to prevent moving during operation.

Fig. 7

Fig. 8

Unit: Millimeters

Fig. 9