Product Manual

ASSEMBLY

ASSEMBLE THE TABLE

1. Assemble the table (Fig. 4 - 1) to the base using two screws.

Thread the screws (Fig. 4 - 2) into the holes of the table and

through the threaded holes on the base.

ASSEMBLE THE FENCE

1. Insert the fence assembly (Fig. 5 - 1) through the hole on the

guide block (Fig. 5 - 2). Ensure that the set screw on the top of

the fence rod collar is tight.

2. Insert the fence lock handle (Fig. 5 - 3) through the top hole

on the fence rod, behind the spring. Tighten the lock lever to

lock the fence in position.

3. Thread the micro-adjustment knob (Fig. 5 - 4) through the

bottom hole of the adjustment plate (Fig. 5 - 5). Slide the mi-

cro-adjustment plate onto the fence rod. Using the included

hex wrench, tighten the set screw on the side of the adjust-

ment plate to secure it to the fence rod. Refer to “ADJUSTING

THE FENCE” section on page 13.

INSTALL THE HOLD-DOWN CLAMP

1. Insert the hold-down bar (Fig. 6 - 1) through the front hole

on the fence rod. Tighten the set screws (Fig. 6 - 2) to secure

the hold-down bar in place.

2. Slide the hold-down clamp onto the hold-down bar. Tighten

the lock knob to secure the hold-down clamp in position.

Fig. 4

Fig. 5

Fig. 6