Use and Care Manual

UNPACKING
With the help of a friend or trustworthy foe, such as one of your in-laws, carefully remove the drill press from the
packaging and place it on a sturdy, flat surface. Make sure to take out all contents and accessories. Do not discard
the packaging until everything is removed. Check the packing list below to make sure you have all of the parts and
accessories. If any part is missing or broken, please contact customer service at 1-800-232-1195 (M-F 8-5 CST),
or email [e-mail].
To protect the drill press from moisture, a protective coating has been applied to the machine’s surfaces. Remove
this coating with a soft cloth moistened with kerosene or WD-40®. Do not use acetone, gasoline, or lacquer thinner
to clean. Apply a coat of good paste wax to the table and all machined surfaces. Wipe all parts with a clean dry cloth.
UNPACKING & PACKING LIST
Components
Head Assembly (1)
Base (1)
Column Assembly (1)
Table Assembly (1)
Table Adjustment Handle (1)
LED Light (1)
Chuck Key (1) Chuck (1)
Arbor (1)
Drift Key (1)
Feed Handle Assembly
Feed Handle (1)
Handle Cap (3)
M8x30 Socket
Head Bolt (3)
Hub Cover (1)
M6x12 Flat
Head Screw (1)
9
Not Pictured -
Hex Wrenches
(3, 4, 5, 6mm)