Use and Care Manual

ASSEMBLY AND ADJUSTMENTS

WARNING: If any part is missing or damaged, do not plug the drill press

in until the missing or damaged part is repaired or replaced.

ASSEMBLY

1. Position the base on the floor. Attach the column to the base

using four M10X30 hex head bolts (Fig. 1).

2. Loosen the set screw and remove the column collar and gear

rack from the column. With the help of a friend, place the rack

inside the table bracket before sliding the table assembly with

the rack down onto the column (Fig. 2). Place the column collar

down over the rack after positioning the rack and the table in

place. Tighten the collar’s set screw with a hex wrench to hold

the rack into position.

3. Install the table adjustment crank (Fig. 3 - 1). Secure it in

place by tightening the set screw (Fig. 3 - 2). This handle will

control the height of the drill press table.

4. Screw the table locking handle into position (Fig. 4 - 1). Tight-

ening this handle prevents the table from swivelling and having

its height adjusted.

5. Install the head assembly with the help of a friend by care-

fully lifting the head above the column. Slide it onto the column,

making sure the neck goes down as far as possible (Fig. 5).

6. Align the head with the base so they are parallel with one an-

other and facing the same direction. Tighten the set screw (Fig.

6 - 1).

7. Install the feed handles (Fig. 7 - 1) into place using three

M8X12mm socket head screws (Fig. 7 - 2).

Fig. 2

Fig. 1

Fig. 3

Fig. 4

Fig. 5

Fig. 6

Fig. 7