Use and Care Manual

10
ASSEMBLY AND ADJUSTMENTS
ASSEMBLY (CONT.)
8. Assemble the hub cover (Fig. 8 - 1) and fasten it in place with
a M6X16 flat head screw (Fig. 8 - 2). Attach the three handle
caps (Fig. 9 -1).
9. To install the LED light assembly, connect the lamp plug
contact (Fig. 10 - 2) to the power source plug contact (Fig. 10 -
3) within the drill’s head.
10. Use four pan head screws (Fig. 10 - 1) to install the lamp
assembly to the drill press head. Flip the LED lamp switch (Fig.
10 - 4) to check if the lamp is working properly.
INSTALLING THE CHUCK
Before installing the chuck and arbor to the drill press head, clean the surfaces with a non-petroleum based prod-
uct such as alcohol or lacquer thinner. Any oil or grease must be removed, otherwise the chuck runs the risk of
coming loose during operation.
1. Push the arbor (Fig. 11 - 1) onto the spindle.
2. Push the chuck (Fig. 11 - 2) onto the arbor.
3. Using a wood mallet (not included), firmly tap the chuck upward into position on the spindle shaft (Fig. 12).
Fig. 8
1
Fig. 9
1
2
Fig. 10
1
4
2
Fig. 11
Fig. 12
1
2
3