Use and Care Manual

15. After turning off the drill press, wait until the
spindle comes to a complete stop before touching
the workpiece. Always turn the drill OFF before
removing scrap from the table.
16. Before leaving the machine, always turn OFF and
unplug the machine, remove the drill bit, and clean
the table. Turn Off and unplug the machine before
cleaning, making adjustments or changing drill bits.
Accidental start-ups may occur if the tool is plugged
in during an accessory change or adjustment.
DRILL PRESS SAFETY WARNINGS
WARNING! Do not operate the power tool until you have read and understood the following instructions and
the warning labels.
17. CLEANING. Never use solvents to clean plastic
parts. Solvents could dissolve or otherwise damage
the material. Use only a soft damp cloth to clean
plastic parts.
18. REPLACEMENTS. Should any component of
your drill press be missing/damaged or fail in any
way, shut OFF the switch and remove the plug
from power supply outlet. Replace the missing,
damaged, or failed parts using only identical
replacement parts before resuming operation.
7