Use and Care Manual

ANGULAR “PLAY” OF THE SPINDLE (FIG. 27)

Move the spindle to the lowest downward position

and hold in place. Try to make the spindle revolve

around its axis while also moving it with a side mo

tion. If there is too much “play”, proceed as follows:

1. Loosen the lock nut.

2. Without obstructing the upward and downward

motion of the spindle, turn the screw clockwise to

eliminate the “play.” Note: A little bit of “play” is nor-

mal.

3. Tighten the lock nut.

USING THE LASER GUIDE

ASSEMBLY & ADJUSTMENTS

WARNING: Do not stare directly at the laser beam. Please observe all safety rules.

• Never aim the beam at a person or an object other than the workpiece.

• Do not project the laser beam into the eyes of others.

• Always make sure the laser beam is aimed at a workpiece that does not possess reﬂective sur

faces, as the laser beam could project into your eyes or the eyes of others.

The laser guide should be adjusted prior to operation. To adjust the laser guide:

1. Mark an “X” on a piece of scrap wood.

2. Insert a small drill bit into the chuck and align its tip to the intersection of the lines of the “X.”

3. Secure the board to the table.

4. Turn on the laser switch and verify that the laser lines align with the “X” on the workpiece.

5. If the laser lines don’t align, loosen the set screws (Fig. 25 - 1) on each side of the head and rotate

the laser guides (Fig. 25 - 2) until the lines meet in the center of the “X.” Retighten the lock knobs to

secure it in place.

Fig. 25 Fig. 26

Fig. 27